New houses that are being built today are pursuing very strict energy efficiency standards. Needless to say, that is not the case for older properties. The most effective thing you’re able to do to make your home very energy efficient is usually to add insulation. Even though it is not practical for you to attempt it within your walls, it’s possible with blown-in insulation up in your attic. You will notice that your property is going to be cooler during the summer months and warmer in the winter months. If you live in an old house, you’ll find that the insulation employed is just newspapers.
You will notice that insulation technology is quite advanced because of our concern for reducing energy and saving the environment. Insulating components receive an R-value, and this value is used to determine the amount of insulation needed, depending on the area of the country you live. In regions which usually get very cold over the winter require insulation with a high R-value while other areas may require just a lower one. Probably the most effective solutions to reduce your heating bill is blown-in insulation. There are many benefits to choosing blown-in insulation rather than the traditional fiberglass insulation including energy efficiency, how it can be used and installation.
Of the top five advantages for using blown-in insulation, the first is that it is adjustable. You can control how much insulation you will need thus varying the R-value. Blow in a precise amount of inches for an R-value of 15, and so much more if you would need an R-value of 38. Another reason to choose blown-in insulation is that its usually produced from virgin materials so there is less chance of getting allergies. Youll also have a more effective seal since the materials can fill in cracks and crevices. Youll find it isn’t going to take much work to install and all open spaces will be filled therefore making your home more energy efficient.
Installing blown-in insulation is straightforward for a newly framed house. All that has to be done is to staple a netting over the studs of the exterior wall and create a couple of small holes, then place a hose in the hole and fill up the inside with insulation. The insulating product blown in sticks to the studs, and completely fills all of the empty spaces. You then contain the wall with vapor barrier and after that drywall it. To perform ceiling insulation, you drywall the ceiling first then go into the attic and blow it in from there. Its more challenging with older dwellings considering that the wall covering will need to be removed. After the wall covering is removed, the steps are pretty much the same. If your household is very old, you could just make a hole in the wall and blow the insulation in, then cover it up.
Even though it gives you a high initial cost, you will save a whole lot of money in the long run. With the lower heating costs, as well as a more comfortable living, having blown-in insulation makes a lot of sense.